Transmisor multivariable JCMC con Hart

JCMC Multivariable Transmitter with hart

The  transmitter  adopts  modularized  design.  It  consists  of  a  differential  pressure  sensor  module  with integrated electronic adapter unit, an amplifier module with a control unit and a two-wire system RTD input terminal to measure process temperature. The sensor module adopts full-welded structure, interior of which is a twin-barrel system with an intact overload isolation diaphragm, and one absolute pressure sensor and one differential pressure sensor are installed inside. The absolute pressure sensor is only installed on the high-pressure  side,  and  the  measured  pressure  will  be  taken  as  reference  value,  in  order  to  compensate influence from static pressure. The differential pressure sensor is made up of one capillary tube connected with negative pole of the sensor module.

An additional differential pressure (Dp) will be applied onto diaphragm of the differential pressure sensor through the isolation diaphragm and filler liquid. Check for tiny variation of the diaphragm, which shall result in changes of output voltage of the testing system. The voltage signal direct proportional to the input pressure will be digitalized through the adapter before being transmitted  into  the  amplifier,  and  then  the  amplifier  will  perform  linearization  on  the  signal  as  well  as temperature compensation. Then, three values of Dp, P and T can be converted signals direct proportional to mass flowrate through compensation. Except for mass flowrate (Qm), Dp, P, T and Qv can also make for other purpose of application. According  to  differences  of  transmitter  models,  connection  between  the transmitter  and  process  can  be  fulfilled  through  female  screw  on  elliptic  flange  on  the  transmitter,  or connection between remote flanges and process pipelines or flanges.

The transmitter adopts a two-wire system, the same pair of leads in which can be used to connect working voltage,  signal  outputs  (4～20mA)  and  digital  quantities.  Electrical connection can be fulfilled through interconnection with terminals through cable inlet.