2 -wire Loop Powered Display LCDD-03
2 -wire Loop Powered Display is a kind of transmitter with an output signal of 4 to 20 mA and an LCD display
The LCDD-03 display is fit for all of the transmitters and converters with the 4-20mA 2-wire technique, just as pressure,
differential pressure, temperature, flow, PH, acceleration, and so on.
- Introduction
- Parameters
- Ordering Code
2 -wire Loop Powered Display  LCDD-03
Performance
All transmitters with an output signal 4 to 20 mA
Feature
* The LCDD-03 display is fit for all of the transmitters and converters with 4-20mA 2-wire technique, just as pressure,
differential pressure, temperature, flow, PH, acceleration, and so on.
* 16 bit ADC MCU inside.
* Customer can use the three buttons to program the zero, span, decimal point, damping and alarm point, etc.
* Over or under range is displayed as a message. The integrated smart diagnostic system continuously monitors
all device functions.
* The programmed parameters are stored in an EEPROM and are kept in case of a power failure.
* The LCDD-03 can indicate the current measurement value input in per sent through bars meter.
* Many kinds of the units can be displayed, such as mA, us, PH, mbar, etc.(Further versions are possible on request.)
* The LCDD-03 display is powered by the current loop of the 4 to 20 mA signal transmitter. No additional auxiliary
power is required.
* Optional: two OPTO switch output
Easy programming with push buttons
Reverse polarity
Low power consumption
LCD can work at 3mA
Optional: two OPTO switch output
Technical dataÂ
Display | |
Type | Visible range 32.5X22.5mm; 5-digit 7-segmentmain display, digit height 8mm,
8-digit 14-segment additional display, digit height 5mm;52 bar meter with 2% resolution |
Range | -9.9.9.9.to 9.9.9.9.9. |
Accuracy | 0.1%1digit |
Digital damping | 0 to 100 s (step 0.1 s) |
Units | mA , mV , V , bar , mbar , Pa , Kpa , Mpa , mH20,cmH20, mmh20 ,mmhG, PSI , TOr , Kg,g , N,KN, °C,°F , K,RH, VOL, PPM, LEL,PH, M, cm , mm , INCN,m/s , Ohm , Kohm % |
Supply | |
Supply | Not required, 4 to 20 mA loop powered |
Voltage drop | ≥3.1 V  |
Electrical protection | |
Short-circuit protection | Permanent |
Reverse polarity protection | Max.current: approx. 200 mA |
Ambient temperature | |
Operating | -30 °C to 70°C |
Storage | -40 °C to 70°C |
Materials | |
Display housing | ABS |
Others | |
Weight | Approx 30 g |
Ingress protection | IP00 (IP 65 when mounted) |
Optional output | Two OPTO switch |
Dimensions |
Dimensions
Application | |
1 | 4-20 ma ( 2 wire ) |
Switch | |
1 | Without switch |
2 | With two OPTC Â swtich outputs |
Housing color | |
B | Black |
Lable | |
1 | Standard |
2 | Customer |